Front end guidance

[541d50]

Okay so I will be ordering all that stuff from RockAuto it is much cheaper than oreilly's. Probably going to be a weekend job and I don't have a garage so I will be rolling around the dirt doing it. Lol

on an up and up note my bada$$ headers from Dom showed up today and I will be using the VHT ceramic coating on them and heat wrap after that then hopefully installing them this weekend. Just need to get a bolt to plug the O2 bung but that's easy peasy.

Also so I know at this point it is pretty much beating a dead horse but I have some conclusions I need verified on my Weber 32/36 install. I have looked in many threads for the info this is just for verification. So when installing my Webber all I must have is the fuel feed line and the distributor advance vacuum line and I can remove all the other emissions crap?

[geezer101]

...So when installing my Webber all I must have is the fuel feed line and the distributor advance vacuum line and I can remove all the other emissions crap?

Yep. Just make sure that if you disconnect anything that pulls vacuum from the inlet manifold, you cap it off. you can even go as far as removing the EGR valve on the inlet manifold and making a small block off plate to seal the galleries (depending on what EGR system is fitted you your engine...)