Quote Originally Posted by Andy 2 View Post
I didn't go into the fuse panel at all. The plug that went to the Mikuni had two 12 volt terminals that came on with the ignition. One was the choke, and the other for the solenoid that leaned out the mixture. I used one of those as my ignition source for the relay and then followed this wiring diagram.elecpump04.jpg
I do not come here very often, obviously. I used an "Add-a-Circuit" to the fuse panel. Andy used a power source at the carb. IIRC, I cut off the plug on the wiring to the Mikuni, this forced me to go to the fuse panel. These pumps do not take a lot of amperage, so splitting a circuit to the dome lite works fine. See the instructions above, but either method is satisfactory.