I am searching for the company that stamps this information on their bearings.
The circle is apparently their logo design they use and I hope that someone can recognize it.
bearing.jpg
I am searching for the company that stamps this information on their bearings.
The circle is apparently their logo design they use and I hope that someone can recognize it.
bearing.jpg
Do you have the original image file? Tried a reverse image lookup on Tineye but found nothing. But A17X means it's made of high fatigue strength aluminum alloy.
Thanks Noahwins about the metal strength stamping info, that's a good start and helps.
I made that image so I could post it in here for viewing. The stamp is on the outer edge of the doner motor rod bearings and these bearings are obviously better quality then the ones in my motor. I want to get the better quality bearing to install into my motor when the crank is finished and I am trying to locate the manufacture. Presently I have Kingbearings installed.
Kingbearing.jpg
This is the stamping on my present bearings. Kingbearing web site shows 2 types, this one I show above is this...
bearing2.gif
8 X
C4481
122CI /2.0Liter
G63B,4G63 L4 SOHC
8 Valves, vin D
Gasoline 02/1980 - 04/1992 1997
85x88 4
CR4481AM STD
and a race engine bearing version...
bearing2.gif
8 X
C4481/PR
CR4481XP
STD/0.25/STDX
Optional to CR4481AM (For race engine)
Rod Bearings, Tri-Metal Performance
(83-92)
Shell No
C4481/PR
Last edited by BradMph; 04-05-2014 at 07:55 PM.
Daido Metal
If you download this file----> http://www.benitomo.com/index.php?op...emid=7&lang=es 2.6 Mb
Then go to page 44-46. It has the Daido reference No. and the corresponding Mitsubishi Part No. according to engine model. Dig it.
.,..or go here----> http://static.shop033.com/resources/...IDO%20BRGS.pdf
Bookmarks