Results 1 to 13 of 13

Thread: Weber 32/36 K614 G63b Bogging Issues

Threaded View

  1. #13


    Array
    Status
    Offline
    Join Date
    05-01-2018
    Posts
    1,549
    Location

    Kailua, HI
    Vehicle

    1986 Dodge Power Ram 50
    Engine

    G54B
    Check List:
    1) carburetor is in good condition, clean & properly ajusted (especially float)
    2) Fuel pressure & flow (gph) checked and sat within specs
    3) Ignition system checked & sat (no weak coil bad wires etc)
    4) Ignition timing initial vacuum cetrifugal all checked sat @ proper idle RPM
    5) Cylinder compression tested & sat (these engines have weak cyl heads prone to cracks etc)
    6) No air or vacuum leaks of intake or exhaust system
    7) Fuel tank drained of old fuel & in tank fuel filter inspected & sat
    8) Add good clean FRESH gasoline
    9) Engine should run ok

    My trucks main problem was EXTRA SUPER ROTTEN YELLOW COLORED CRAP BAD ANCIENT OLD WATER & GUNK CONTAMINATED FUEL & WEAK FUEL PUMP it ran bad until those two items got fixed... I don't experience actual vapor lock but I notice the carb is receiving about 50/50 gas vapor bubbles & liquid gas...

    Good Luck Fixing misosoup
    Last edited by xboxrox; 04-07-2025 at 06:27 PM.
    Daily Overhauls Do Get Expensive

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •