Results 1 to 2 of 2

Thread: Getting a 2.0 to run

  1. #1

    Array
    Status
    Offline
    Join Date
    03-08-2024
    Posts
    1
    Location

    Fresno, CA
    Vehicle

    1985 Dodge Ram 50
    Engine

    G54B

    Getting a 2.0 to run

    Hey everyone,

    I pulled a motor and transmission from a 1988 Mighty Max. Iím trying to figure out how to have the thing run while outside of the truck. It has one of those dual diaphragm distributors that Iím trying to figure out the vacuum lines for as well as I bought a Herko B108 coil that Iím trying to figure out how to wire up properly. I dropped the Mikuni carb for a Weber, so thatís also been simplified. My main issue, when it comes down to it, is properly wiring in the coil so I donít blow anything up. Any tips (and hopefully pictures and drawings for my simple mind).

  2. #2



    Array
    Status
    Offline
    Join Date
    03-06-2018
    Posts
    506
    Location

    Tucson, AZ USA
    Vehicle

    1987 Dodge Ram 50
    Engine

    G54B
    This thread should cover everything you need to know:

    http://www.mightyram50.net/vbulletin...on-coil-wiring
    1987 Dodge Ram 50 4G54 RWD longbed ("Elmo")
    1979 Lancia Beta Zagato spider ("Lola")
    1982 Lancia Beta Zagato spider ("Luigi")

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •