Hello this is Spike, i will continue with my provious post.
have a 93 mighty max 2.4l aprox. 180K well maintained always runs well until about a week ago. after a short drive restarting is a 50-50 until an hour or so goes by then all seems to be fine. i started looking into it, just a basic look over at first, I pulled the codes that were stored, it showed TPS &Motor Position sensor, So i pulled plugs,ran a vacuum check found a crack on a plug at rear of plenum, replaced it, checked compresson check~ 150 /135 /143/150.. front to rear. as for emissions TPS, IAV, Motor sensor, coolant temp. sensor ( fell apart when i pulled the connector the top of sensor came off with it ) I thought ah ha. of course i tested it and and it was good but i got a new one.

since my tools were out i decided to look at things that wernt looked at for a wile, timing belts, the EGR system, cleaned the air flow sensor , PCV, and basicaly cleaned up the engine that i could now get to , lubed the front end, new coolant. that is basicaly it to date.

now from the time this no restart began ti had gotten more and more frequent which seemed to me the issue was not something that just stoped working it was detorating progressively. so i buttoned it up to run it to test the fuel system and more vacuum wile running, it started right up rah fine, i shut it off to hook up for testing and it would not start. i checked for any new codes stored since i let it warm up and there were none. This is my adventure to date, i am not done so therefore i have alot of information for when i get back to it. besides the tests i am set up for i want to know to get to the crank angle sensor, it being in the distributor is no thing but i do want to look into it. has anyone done this or have info on that process? also, for what i have listed so far please give me any and all advice that could share and don't forget your opinions, those are priceless. Thanks alot in advance for your time reading. and i look forward to sharing the same with you .. Spike