Results 1 to 2 of 2

Thread: need help with weber throttle linkage

  1. #1

    Array
    Status
    Offline
    Join Date
    09-07-2011
    Posts
    29
    Location

    midlothian virginia
    Vehicle

    1988 Dodge Power Ram 50

    need help with weber throttle linkage

    i have a 2.6 and bought a weber carb

    and i am having a killer time trying to figure out how to mount the throttle linkage up ...
    i tried a nut and bolt but it keep moving after i press the gas pedal

    how did you guys get it to work?

  2. #2



    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,115
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    The kit should have come with an arm to attach the cable with a "floating pin" setup that rotates in the hole as the pedal is depressed. If you are using the stock arm from the mikuni carb, it will slip if you don't use the star type lock washers or fill and reshape the hole to match the weber shaft. If I get a chance, I will be a closeup of my linkage on Geronimo with a 2.6 5spd and a 32/36 dgev weber - my linkage is under the carb bowl in front, rather than the linkage in the back like the mikuni.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •