I had a HORRIBLE time rebuilding the OEM 5 speed shifter. The pin simply would NOT press out. We finally won using a 30 ton hydraulic press and heat, but there was much “carnage”. Anyway, while I was trying to repair the carnage on the OEM shifter, I thought, “Hmmmm. That setup really looks like a T5 setup in a Mustang.”
Sooooo, since I had a cheap eBay shifter for a mustang laying around I decided to play. Below are photos of what I ended up with. It was surprisingly easy. Some drilling/facing and some turning on a lathe (which could probably be done by hand). Add some sanding for clearance, fabricating a gasket, and a few parts.
The only thing is you have to “reassemble” the shifter in the car since the holes to bolt to the transmission are under the top part of the shifter. Hardest part is not dropping the tension springs and bushings. Other than that it was real simple. I used the shifter base as a pattern for the bolt holes.
Sadly, the OEM shift boot won’t fit over the large T5 shifter, so I’ll have to fabricate something for the shift boot (probably sew up a leather shift boot for both shift levers). And I need to fabricate a shift lever still. The setup in the photos is simply for testing.
There’s a lot more that could be done like removing the excess from the shifter base, but everything fits as is without any modification to the truck.
I haven’t driven it yet (still no brakes), but it feels like it is going in each gear just fine.
Anyway, just my solution.
Cost:
T5 Shifter bushing installed:
OEM Shifter bottom installed:
Bolt hole pattern transfer from OEM shifter bottom:
Bolt holes faced and sanding for clearance to the 4wd shifter:
Shifter base installed:
Shifter Upper part installed:
Finished with the dust cover/seal installed:
Bookmarks