Quote Originally Posted by pennyman1 View Post
Use a dolly and hammer, heat the metal and then hammer it out from the inside - this is hammer welding the seam.
Can I use my dinky little propane torch? or do I need the real thing? I know on older cars where the sheet metal is much thicker they used to heat it cherry red and then quench it with a wet rag and that would shrink the metal back down.

Hammer weld the seam? The low spot on the door is not really on the door handle patch but lower down where i wasnt welding. I dont think I can get a good pic of it. I might try going over it with a flat board so you can see the low spot from the paint that doesnt get hit by the sand paper