Have 88 Ram 50 sport 4WD. Pulled trans and had it rebuilt. Upon trying to reinstall it we can only get it to about a 1/2”-3/4” from mating to engine. I have tried the following:
1) put drive shaft in to try and rotate spline to slide home. No luck
2) put wrench on crank and worked that to see if that helped.
3) installed pins in the mounting holes to help with alignment.
4) installed cross member to try and help with alignment, again no help.
last thought is to install longer bolts and pull it in that way but I don’t want to damage the pilot bearing.
any help would be appreciated...
thanks,
Mike
Bookmarks