Results 1 to 3 of 3

Thread: Holley sniper efi

  1. #1

    Array
    Status
    Offline
    Join Date
    11-17-2018
    Posts
    9
    Location

    Wasilla, AK
    Vehicle

    1989 Dodge Ram 50
    Engine

    G54B

    Holley sniper efi

    Anybody out there adapt one of the Holley sniper efi systems to a gen 2 ram 50 2.6 manifold, if so what adapters did you use to adapt it and what did you do for throttle cable setup.

  2. #2

    Array
    Status
    Offline
    Join Date
    06-15-2014
    Posts
    6,059
    Location

    Adelaide, South Australia
    Vehicle

    1985 Mitsubishi L200
    Engine

    G63B
    The sniper EFI has been talked about on the site but I think after reading up on cost it was deemed not worth it. I don't think there's a specific adapter plate for it but something like this might be a way -

    https://www.ebay.com/itm/Adapter-Pla...kAAOSwmphaKNJ-

    You need the sniper kit, a high pressure fuel pump and the adapter plate. The throttle cable set up should actually be the easy part on this.
    support the forum that supports you - join and donate to MightyRam50.Net today! donations unlock the edit function

  3. #3

    Array
    Status
    Offline
    Join Date
    11-17-2018
    Posts
    9
    Location

    Wasilla, AK
    Vehicle

    1989 Dodge Ram 50
    Engine

    G54B
    Do not think that pattern will work, on my 2.6 manifold the bolt spacing is 1.75" x 3 3/16" (44.45 x 81)

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •