Ha, I read over your posts a few times but it made no sense at all at first....
After the light also came on on my "Single", I went hunting some more about the light. I was not very successful. At least not directly as to why or how the light even turns on. I was able to find a place on this forum ( somewhere ) that talks in more detail about the light and where to find this "reset switch"

Under the steering you have the hazard light switch to the left, on the right you have the same space for a switch just like it. The right side is covered by a blank cover though. Remove the cover and if you shine a light in it, you see a tiny little switch in the upper right ish corner rather far back in the space. You either move the switch to the left or right depending on what location you find it in.

So, now I have both "Single" and "Macro" running without any warning lights. I do think that the "hot rod" kid changed some of the cluster lights with LEDs......
damn they are blinding at night. Why does everyone like the rediculus ultra bright ( I am going to blind you ) lights.....
I will be pulling the Marco's cluster out and putting normal lights back in or if I go LEDs, at least something of the normal light brightness range.

Sure has been quite on here the last few weeks, probably due to the virus.
Hope you are all healthy out there.
Say hey sometimes :D ( I should probably read the forum more also :D )