Before I begin my electric fuel pump install...

[RamRock50]

Hello everyone,

After getting my weber carb installed (finally!) and checking out mopar_ja's fuel pump install writeup (thank you, mopar!!), I feel like I am almost ready to tackle this project. I want to ask a few questions before I get going, though, especially since I do not see myself doing any more upgrades after this, unless it is a necessity. Here we go!

First, I went ahead and found most of the parts mopar used on Amazon with links below:

• Carter P4070 In-Line Electric Fuel Pump
• Professional Products 10216 Red/Blue -6 AN Inline Fuel Filter (According to the description, it is the same as the 10211 spec wise)
• ALLMOST 40205G Electric Fuel Pump Harness and Relay Wiring Kit NEW (Different brand, but spec-wise, and according to the fact that mopar and an Amazon reviewer had to use a longer wire for the relay-to-pump connection makes me think that this is otherwise the same kit used in the install writeup)

Now for the questions:

1. The Carter P4070 does sound a bit beefy, doing 72gph. Would it be safe for me to downsize to something that does 30gph, assuming it still has good (5-9) psi? If so, I was looking at the Universal Electric Inline Fuel Pump E8012S HEP-02A.
2. There are not a lot of 10216 filters available (only 1 at the moment) and shipping is a factor for me, so if I have to go with an alternative, will the Billet Aluminum Inline Fuel Filter + Bracket Cleanable 30 Micron for AN6 AN8 AN10 Black suffice?

That is all I have for right now. While I wait to get these parts ordered, I will work on getting all the other stuff ready. Any feedback is much appreciated. Thank you!!