Results 1 to 4 of 4

Thread: Intake manifold ports

  1. #1

    Array
    Status
    Offline
    Join Date
    07-08-2018
    Posts
    30
    Location

    liverpool ny
    Vehicle

    1984 Dodge Ram 50
    Engine

    G63B

    Intake manifold ports

    I have been in the process of trying to make and adaptor for the stock 2.0 manifold to the Holley sniper 2300 ebbs unit and was curious about these two ports and where they go. And what can be blocked off. I already have the egr blocked off.
    10D4F6AD-F48E-4F30-B346-1923CBD47180.jpg

  2. #2




    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,851
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    small one is air port for jet valves, large port is feed to water choke on mikuni carb. Block them both off with allen head setscrews secured with Loctite red.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

  3. #3

    Array
    Status
    Offline
    Join Date
    07-08-2018
    Posts
    30
    Location

    liverpool ny
    Vehicle

    1984 Dodge Ram 50
    Engine

    G63B
    ok thank you so much, iv been thinking of what the smaller one could be but couldn't think of anything.

  4. #4

    Array
    Status
    Offline
    Join Date
    12-01-2013
    Posts
    81
    Location

    Great Falls, MT
    Vehicle

    1988 Dodge Ram 50
    Engine

    G54B
    Did you happen to get the 2300 Holley efi setup to work?

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •