So today I re-modeled the gauge cluster I designed to fit in the Mighty max dash. Because the wideband I ordered has a much deeper bezel than other 52mm gauges it stuck out way to far for my liking.
The new piece has a sunken area for the gauge and is 5mm thicker on the front to try and level things out a bit.
Ignore the RPM gauge, thats just a old busted gauge for test fits etc
Here is the original 3D printed cluster with the wideband sticking out too far
cluster v1.jpg
New cluster
new cluster.jpg
Here is the new Vs old cluster
cluster side by side.jpg
New set up all ready for some primer and paint, unless I can get some affordable black ABS filament for the 3D printer and then I'll print a new one and smooth it off with acetone
new cluster 2.jpg

Cheers
Alec