Thanks Pennyman and Geezer.
I did the shocks a year or two ago hoping to get what I am hoping for from the husky springs, better load support. It bottoms out on the stops when I get heavy loads dumped in. I had to loosen the lower end of the shock on the Drvr side to get the husky spring mounted. when I tightened it back up it is tight against the bar the U bolt goes through. The passenger side is clear.
I added the husky springs and did the bushings today. I took it apart yesterday and cleaned things up and painted what I could knowing the bushings would arrive today.
I forget exactly when but about the same time I did all the front end joints and new calipers. shocks, brakes etc I also did the rear brakes, completely and got new drums not knowing the ones I had were fine. The only thing not new in my brakes are the master cylinder, hard lines and the emergency cable. The soft hoses are new from when I did them too.