bed interior

[85Ram50]

Got the bed done. I was not happy with the primer cans. They started spitting globs from the start and did not fully discharge. I was not able to coat the tailgate with the epoxy primer. The Raptor sprayed like a dream and I have no experience other than about 20 minutes of instruction on how to paint 39 years ago. The 10gal air compressor I bought for the job worked fine. It ran a lot but there were not hiccups. I never had to wait for it. I used a setting around 55psi+. The gauge is not broken down smaller than 10psi increments. So if any of you were ambitious enough to try it go ahead. The prep is the hardest part.
Raptor primer.jpg Upol1.jpg Upol2.jpg

When it is dry I will get the lights back on and test drive it with my new fuel pump.

Edit- Well it is dry to the touch. 7 day cure, 72 hours stay dry and it has started sprinkling. I hope it just gets misty and moves on. Had to drill out the tailgate screws to get in and fix the latch pull that came off. So now I have to find machine screws for it tomorrow. Tailgate is on sans removable panel.
Geez the rattle can is the same brand as the liner. It is one of the special kind with the push pin on the bottom. It had a turnable fan sprayer but the rest of the nozzle looked like a regular style.