EF02889E-3056-4DE8-A7CF-19273201CBFF.jpgNew member here, had the truck going on two years now. 168k recently had the balance shaft belt break which caused the timing belt to break. Good thing these 4g64 8 valves are non interference. Recently after search for over a year I finally found a donor truck to fix my wrecked front end. Currently running 3” blocks in the rear and 16x7 montero wheels. Looking to go a couple inches lower. Gonna pull one leaf from the rear to get it where I want. Cut the bump stops down quite a bit so I can have at least a little travel. Does anyone have suggestions on lowering the front? I’ve read the post about QA1 coilovers with mustang springs. Are there any cheaper options besides the classic cutting a coil off the springs. Looking forward to meeting some people considering getting any amount of help locally is like a needle in the haystack.