Results 1 to 3 of 3

Thread: In line lift pump?

  1. #1

    Array
    Status
    Offline
    Join Date
    05-09-2019
    Posts
    3
    Location

    Temecula, California
    Vehicle

    1984 Mitsubishi Mighty Max
    Engine

    4D55-T

    In line lift pump?

    Hey y’all,
    1984 mighty max 2.3 4d55t
    I’m new to the forum, but I’ve been lurking here trying to gather info for awhile. I’ve been trying to diagnose a fuel starvation issue, or that’s what I think it is anyway. The truck would run decent for different periods of time, 20-45 minutes, then would begin to sputter and die out. I recently replaced the fuel tank because there was loads of rust and gunk built up inside of it. That seemed to help a bit, but I still get starvation issues under WOT in third which will cause the truck to die after 3-4 seconds of WOT. I was debating putting an in line transfer pump from the tank to the filter housing. I wanted to ask the greater knowledge base here for advice and direction. Thanks in advance!

  2. #2

    Array
    Status
    Offline
    Join Date
    06-12-2015
    Posts
    185
    Location

    Owensboro, KY
    Vehicle

    1991 Dodge Ram 50
    Engine

    4D56-T
    I run a 60 gph electric pump between the fuel tank and the fuel filter. Haven't had a single problem with that setup

  3. #3

    Array
    Status
    Offline
    Join Date
    05-09-2019
    Posts
    3
    Location

    Temecula, California
    Vehicle

    1984 Mitsubishi Mighty Max
    Engine

    4D55-T
    Awesome thanks for the reassurance, I’ll be ordering a pump today!

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •