Page 4 of 4 FirstFirst ... 234
Results 76 to 77 of 77

Thread: 1991 monty max 4x4. V6 to 4g swap & RHD. need 4g fit aide

  1. #76

    Array
    Status
    Offline
    Join Date
    10-22-2015
    Posts
    245
    Location

    Nevada
    Vehicle

    1990 Mitsubishi Mighty Max
    Engine

    Other
    That canister is for your rear ABS.

  2. #77

    Array
    Status
    Offline
    Join Date
    03-02-2019
    Posts
    52
    Location

    East Haddam, CT
    Vehicle

    1991 Mitsubishi Mighty Max
    Engine

    6G72
    Quote Originally Posted by geezer101 View Post
    Grrr of all the places to blow holes in a panel, the roof turret is the worst place to do it.
    i know right? idk if im gonna tryin weld them up, or just dimple eash hole in a little bit, & use this underwater
    fairing filler for sailboats that my dad uses, stuffs even petroleum resistant. ive used it to replace shifter bushings
    on my e30 and covered in grease theyre still tight 5 years later... not big on filling holes but i dont know if heat
    is gonna be a good idea on that paper thin roofskin. i dont want to warp it any worse than it is already.

    Quote Originally Posted by Chargerx3 View Post
    That canister is for your rear ABS.
    ABS? then its outta there! what does that line going inside the cabin go to??? i havent and am not sure if i want to
    pull that rear interiour panel off...

    if i am indeed going to remove that rear load-sensing proportioning valve contraption, as i believe i am, then
    i was curious if i should keep the x2 lines that go back to the rear axle, or just run a single back and tee it
    to either side???

Page 4 of 4 FirstFirst ... 234

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •