i finshed the clutch pedal support backet, just need to weld on m8 nuts and spot-weld the whole thing
onto the firewall above the column:
Attachment 22026Attachment 22027Attachment 22028Attachment 22029
IF that damnable steering box and idler arm ever show up, the next thing is going to be cutting and modifying
the steering column support bar that mounts under the column from the side of the cab to the bolt-in upright
at the center console. the long side needs to switch with the short side thusley:
Attachment 22030
then i think im going to re-use the upper column support, its just so pretty.
but in all honesty, i can actually re-use it because the firewall on the right side is the same height and
shape as the left. most of the other parts were at different distances from things in there new RHD locals...
columnsuppupper.jpg
im planning on replikating the OEM pajero dashboard out of sheet steel, its all straight bends across the span
of the wind screen so i shouldnt be too difficult to do. ill probly omit the middle vents as i never
use them:

i was thinking about using an oem center console, but i kind of like the fact i can cut/weld and mount anything
i want to it, not to mention repairs or further modifications. i like the look of the mkI dashboard alot,
much better than the mighty max's.

so nice and simple and clean and sharp looking.