Well guys,
We have the answer. I tore the front end off the engine apart again. When I got the lower case under a 10x magnifier I found a small hole in the casting. More Chinese quality control. I am certain I could return it to Amazon but where does that leave me? My original problem was, in my opinion, a bad pressure relief valve. I cannot find the parts to fix. So I am going to clean up the original front case and put the parts from the new one to, I hope, fix my problem. And Mr. Geezer I have fixed the turbo problem. I have a Garret water cooled on this unit and some corresponding sized exhaust. My new lower gasket set has been shipped from RockAuto should be here soon. The adventure continues.