Storage boxes would definitly be the plan. Right now I am just figuring out my next welder.
After some reading, I think I will go with the Hobart 140. Standard household power is mostly needed, even though 3 phase is available at work.
Plus cost is an issue, I dont have $1,000 for a machine this year, just too much going on to figure it in.
I found an old piece of roll bar that I will use for a temporary headache rack.
Also, realistically the flatbed is built more stout(heavy) than I need. Next year I will build something different(lighter), but this should work for now.
The way the frame rails line up with the flatbed rails, I shoukd be able to make quick mounts for the rear end, however it is going to take a little more creativity to make front mounts, since the rails basically sit on the mounting pad.
The bed is pretty much sitting near the height it will be mounted to. Josh
Reply With Quote
Bookmarks