[Front]

(I suggest doing one side at a time and PB Blaster and a BFH lol)

1. Remove nuts and bolt that holds ur sway bar and the two nuts underneath the bottom A arm that holds the strut bar and holds the bumpstop. (remember to cut the bumpstop in half for a smooth ride!)

2. Remove tie rod end off of the spindle.

3. Remove shock completely.

4. Put jack under control arm just barely underneath about a 1/4 inch so it will catch it.

5. Remove cotterpin from bottom spindle mount and loosen the nut dont take it off all the way so when you knock the side of the control arm it will pop the spindle up and the control arm down hince having the jack underneath the control arm to not let spring hit you in the face.

6. Lower control arm slowly and you might have to wrestle with the spring to manuevor it out of the spring pocket.

7. I cut mine 3/4 of a coil to get a 1 inch drop to level my truck from having the 3 inch blocks in the rear with all the rear springs still in place which included mine with 2 actual springs and a Helper spring.

8. Just install in reverse order.