[Rear]
(Get on level ground and 2 sets of floor stands and a good hydrulic jack and either cut or remove bumpstops!)
1. Jack hoghead up high enough to put ur 1 set of jack stands underneath the frame rails.
2. Add you second pair of jack stands underneath the axle tubes and lower the axle just enough the whole axle sitting on jack stands but leave jack under hoghead snugged up to it.
3. Remove shock bolt that attaches to the leaf spring bottom plate.
4. Remove the U bolts and spring bottom plate.
5. Remove bolt from emergency brake cable.
6. Put in ur 3 inch blocks in and spring bottom plate and supplied U bolts and lock washers and nuts. (remember to cut your U bolt ends after you tighten them up so you dont scrap or hang up on something.)
7. Replace bolt for emergency brake cable and shock nut back on the bottom spring plate.
8. Jack up hoghead to remove the jack stands underneath the axle tubes and then jack up one side of the truck to remove the jack stand from the frame and then to the other side of the truck.
9. Enjoy!
Bookmarks