Results 1 to 5 of 5

Thread: Rear interior panel

  1. #1

    Array
    Status
    Offline
    Join Date
    01-24-2017
    Posts
    1,209
    Location

    New Zealand
    Vehicle

    1981 Mitsubishi L200
    Engine

    Other

    Rear interior panel

    Today I made up a ply panel for behind the seats. After drilling holes along the top edge I realised I have nowhere on the bottom to mount to, the rear floor seam of my cab has all been replaced.

    Could anyone show me what should be there? My parts book shows 4 points along the bottom edge

  2. #2

    Array
    Status
    Offline
    Join Date
    06-15-2014
    Posts
    6,059
    Location

    Adelaide, South Australia
    Vehicle

    1985 Mitsubishi L200
    Engine

    G63B
    There are a couple of supports that are spot welded to the bottom of the rear cab panel. The top part of the trim panel is held in place with 5 plastic mushroom lugs that run along the lower edge of the cab brace under the window.
    support the forum that supports you - join and donate to MightyRam50.Net today! donations unlock the edit function

  3. #3

    Array
    Status
    Offline
    Join Date
    01-24-2017
    Posts
    1,209
    Location

    New Zealand
    Vehicle

    1981 Mitsubishi L200
    Engine

    Other
    Are they just C shaped bits?

  4. #4

    Array
    Status
    Offline
    Join Date
    06-15-2014
    Posts
    6,059
    Location

    Adelaide, South Australia
    Vehicle

    1985 Mitsubishi L200
    Engine

    G63B
    They're a straight strip of metal with a step bent into the centre of them, spot welded to the rear panel ribs. 2 either side of the trans tunnel about 4-5 cm off the floor. They look like they only space the trim panel away from the rear of the cab enough to match the inner ledge of the cab brace under the window.
    support the forum that supports you - join and donate to MightyRam50.Net today! donations unlock the edit function

  5. #5

    Array
    Status
    Offline
    Join Date
    01-24-2017
    Posts
    1,209
    Location

    New Zealand
    Vehicle

    1981 Mitsubishi L200
    Engine

    Other
    Cool I think I have the remains of some old spot welds there. I'll figure something out

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •