Found a line on a Gen 2 Monty front end, Control arms to hubs(rotors and calipers). And a conquest differential. I need to look up what else I need for the Conquest as far as plumbing and all. But I figure I will order them tomorrow, then fresh urethane, tie rods and ball joints, might want fresh rotors and pads too.

Are there any other parts I need for the Conquest differential mod? Is the Gen 2 Monty lower arm interchangeable with the Gen 1 Mighty Max? Can I use my locking gen 1 hubs on auto hubs from the Monty? Are there better/other locking hubs I can use with more common bolts?

Not sure about shocks yet but I should make a decision. Budget is getting tight.

And that should be it for this chapter of the build. Get the front end figured out. Then play with the clutch. Fix the big holes. Then the rear end.