I ordered the front cable, and both rear cables. Bed is 72" / 105" wheel base so I ordered those cables. As well as new shoes and pads for the front and new rear wheel cylinders, since they're cheap enough I don't see much value in rebuilding them as cheap as they were. I also got to poking around under the hood more, got some questions as well as showing some retarded shit.

Like this...What kind of fuses go here? Because this is just dumb.


What's the blue plug(s) for? What circuit? They wouldn't reach without messing with stuff so I figured I'd ask before trying to connect an unknown wire.


What's this big plug ugh supposed to go too?


What the hell is this? Has nipples for vac lines that are no longer hooked up, but also has an electrical plug and wiring going in the bottom, was unsure if that needed to still be hooked up for anything so I didn't remove it.



Why does a carburetor need electricity? Electric choke? (remember I have never worked with carbs)


Why the hell is there an O2 sensor on a carbed engine?????


None of this emissions stuff (charcoal canister etc) was hooked up so... bye I keep all those little connectors and stuff though, they come in handy at times!