Reverse Switch Ball Specs

[Chyrio]

As requested by Geezer I did my best to get the specs for the little metal ball for the reverse switch. I don't have calipers but I tried to use my little multi measurement thing to give you guys a good idea. In the 5/16ths hole and 8mm the ball is just big enough that it slides in and out of the hole with no resistance.
IMG_20170825_205326.jpg
IMG_20170825_205422.jpg
This measurement is in millimeters so as you can see its like right in the middle between 5 and 10mm
IMG_20170825_205546.jpg

[geezer101]

bravo. With pictures...and everything. And as I suspected they are the same size bearings used in old school 1 piece cranks (10 ball cage bearings) so, for for a few bucks you'd get a handful of them. The actual size in mm is 7.94 (for anyone who is about to look it up)

[85Ram50]

Thank You Chyrio! Now I just have to find an 8mm ball and figure out where the 5/16 ball that did not come out is

[BJH324JH]

Thanks Chyrio for taking the time to make this thread. You are awesome! Just to add to the thread, here is measurements taken with a digital caliper:

Millimeters:
20170826_025236.jpg

Inches:
20170826_025502.jpg