Just pulled the tranny out of my 88 D50 2.6 for the 3rd time, had a trans shop rebuild it a couple of years ago almost $1,200 so I expected it to be right! I dropped off the trans and it sat there for a year and I called and had to refresh their memory and help them identify my trans, 2 months later and several calls later they call and it's done. Pick it up and put it in, no first or reverse just a total mess.
I get the truck down to the shop 60 miles away and they work on it and say it's ready now. so I drive it and it's noisy still and the 4th gear barely goes into place seems to hang on the edge and not dropping into place like it should. I needed the truck so I had to drive it for 6 months then like I figured the 4th gear is not holding now and of course it's still noisy. Not sure if the transfer case is making the noise or they never put new bearing in the trans at the rebuild time.
My question is can a guy adjust the 4th gear cluster or shift rods to fix this rather then taking it into another trans shop and paying more for a adjustment?
Bookmarks