Yup, so the door had been bent out to fit the will
IMG_20190906_162645.jpg

I ended up totally reshaping the lower body line of the door. It was different between the b pillar, door, and guard.
IMG_20190906_162705.jpg

Once I hung the door, I lined the rear edge up with the B pillar frame.
With some tapping I got the lower edge parallel and inline with the sill.
But now I couldn't open or close the door....
Panel gap at the guard edge was all over the place. I ended up redoing the whole rear of the guard. An old Taiwanese reproduction. In some places out by 5mm + or -. And the rear mount had been welded on crooked.
IMG_20200227_184532.jpg
IMG_20200227_185151.jpg

It's pretty good now.
Some fine finishing and I can prime it up and get this back on its wheels