A nice little project over my morning coffee
Replacement rear splash shield for the LH side





Original was 1.2mm, the wee bracket was 1.6 ish. I have 1mm and 1.6mm steel here, so everything will be replaced in 1.6mm for no reason other than I already have it.
Not sure if those 2 holes have any use, the shield doesn't match the contour of the skirt panel, so possibly they are for a plastic shield.

It looks like some past repairs have gone on in the LHS wheel well as the panels and seams are a little different from the other side and its missing an angle iron strengthener. Perhaps it was just made this way, as theres no obvious join line