Have had a bit of an oil leak, getting worse over the last few months, looked like the power steering pump. I think probably just the reservoir o-ring, but I got a whole seal kit anyway




looked decent inside, and has been good the last couple of weeks

Got stuck into some more rust this weekend
had planned to do some down in the sill, but wanted to clean up some of last times stuff. This got me to picking scabs. It all looked good with the paint on, but I had been getting some water dripping from the upper door trim plastic, it could only be coming from a hole in the rain gutter, so I stripped it back



yup pretty manky, about a 1/4 inch of bog up the a pillar and roof, I think theres a lot of bog on the roof as some has cracked (probably before it was even painted because the clear coat is smooth over it), some rough old patches, and some good old space age nu-tech better than metal filler

chop it out
Coming in though the bottom too

so cut that out as well




door frame back in

found some more filler on the corner, theres an aweful lot of nutech near the screen seal, from what I can see through the hole it doenst look like its full of holes, probably just the good old technique of bash it in with a hammer and fill over everything


I'm wanting to use the truck so I cant take the screen out right now, but at some point il take it out and baremetal the roof


all patches in, looks rough as can be because theres a step down on the roof filler to the metal, oh well, hopefully I get some time off this summer and il get it looking decent