So iv had a week off, but have sat inside bored out of my mind because I did a half assed job at removing my fingers last weekend
Sun came out and I can sort of use the hand as long as I don't reach for anything or lift with the thumb

so this was pretty difficult


removed seats


not as bad as it could be

Front corners and back of cab are all rough patches




New floor covering I picked up. not sure who made it it was just wrapped in a plastic sack with L200 80-85 single cab written on it. No cut out for the shifter so probably aftermarket

bit of sound deadening on the back



Its a poor fit tbh, theres no cut out for the steering column, yet the edge is all bound and it doesn't like the corners.

I stuck it roughly where I thought it should go and screwed all the edges down, cut the shifter hole, the went at it with the heat gun and blocks of wood to contour the sills. It needs a lot more of that action but it fits in now.

Vacuumed off the speaker box material that was in the back and put the seats back in. The loom from the tunnel is too short to go up behind the carpet and underneath so I had to de pin a plug and run it over the top for now. so bad,


also fixed the folding forward passenger seat so it locks back in place


ADEQUATE