INSTALLATION
1. Rotate crankshaft until piston of No. 1 cylinder is at top dead center on compression stroke.
2. Align mating mark line on distributor housing with punch mark on distributor gear, Fig. 5.
3. Install distributor onto cylinder head.
4. Align mating mark on distributor attaching flange with center of distributor flange stud, Fig. 6.
5. Install mounting nut, then install vacuum hose(s), wiring harness and distributor cap.
6. Check and reset ignition timing as necessary. Refer to ``Tune Up'' for procedure.
Reply With Quote
Bookmarks