I don't have the capabilities of doing that. I was able to get it out a little but I still need it out about another inch. I ran some measurements and it has about an inch to go. If you look at the photos you can see that it crunched pretty bad. If it gets covered up I'm not to worried about it, but the wrinkles on the fender I'd like to get rid of to make the engine bay look good. I'm doing a wire tuck and painting it up. I'm a newb at some of this and I'm not afraid to cut that section out and replace but I have to find a place to get the replacement. I've called the salvage yards near me and nobody has a mighty max but I didn't ask about a d50 opps. I didn't think about it at the time. Thanks for the response. I just want this to be done right the first time so I do not have to do it a second time. There's no better time to do it than now. 20161012_173152.jpg20161012_194232.jpg20161012_173141.jpg