I have pictures and I have the fender off. The hinges don;t look so bad but the door closes poorly now and it drops a 1/4 inch to 3/8 inch when it has that initial pop out after pulling the handle. Nothing on the pillar looks bent. It might actually be the door sheet metal where the hinges mount that bent. I haven't figured out how to check that yet.
fender damage.jpg fender off.jpg
Pulling the fender. There is a bolt inside the door lip at the top of the panel at the base of the roof pillar and another behind the bumper end. Then there are the easy ones 3 in the fender well. Two at the base of the door/panel meet point. and another under the bumper at the bottom of the fender. Taking the fender end off is a pain. You can only get at the top and bottom bolt easily the middle one is a PIA 1/8 turn at a time. Do it first that way you can release the lower fender. the top of the fender inside the closed hood is easy enough but it has bitumen tape holding it down. I used a painters scraper and cut it without prying up on it and it worked well.
Turns out I do have some rust where the two bolts hold the fender at the bottom next to the door.