If you remove the factory bottom plate off the arm, open the hole in the arm, then weld on a new plate that is heavier for the lower mount on the coilover, that would be the best route. I have seen that done on these arms somewhere before.
If you remove the factory bottom plate off the arm, open the hole in the arm, then weld on a new plate that is heavier for the lower mount on the coilover, that would be the best route. I have seen that done on these arms somewhere before.
Pennyman1
The best Dodge that Dodge never made
Living the D-50 lifestyle since 1980
100% agree. thats my plan if things dont sit low enough once the truck is on the ground. I'm really hoping that the drop spindles save the day.Originally Posted by pennyman1
Reply With Quote
Bookmarks