Fuel pump block off plates?

[geezer101]

If it's a first attempt and this stuff is new to you don't give up. You gotta start somewhere (and anyway the first attempt is your prototype telling you where you went wrong so you can make the necessary changes to get it right)

that is right - someone that knows about how a weber works - but the plate goes on the head, not the manifold. Take him the fuel pump spacer or gasket and have a plate made to match the outline.

If you delete the EGR valve on the inlet manifold it will require a block off plate. But even then that is only cosmetic really as the EGR valve will be non functioning without a vac line to actuate it.

[Kerrigan]

Will omitting the ERG valve effect engine performance with the Weber?
I'm going to give it another try on the fuel pump plate.

If it's a first attempt and this stuff is new to you don't give up. You gotta start somewhere (and anyway the first attempt is your prototype telling you where you went wrong so you can make the necessary changes to get it right)



If you delete the EGR valve on the inlet manifold it will require a block off plate. But even then that is only cosmetic really as the EGR valve will be non functioning without a vac line to actuate it.