Results 1 to 7 of 7

Thread: New Member S.C.

  1. #1

    Array
    Status
    Offline
    Join Date
    03-22-2016
    Posts
    9
    Location

    Easley S.C.
    Vehicle

    1987 Dodge Ram 50
    Engine

    G63B

    New Member S.C.

    What's going on everyone!? I'm a new member to the forum. I have an 87 Dodge Ram 50 2.0!! It didn't come with lower steering so I purchased a setup to install it on my truck from a MM. I have everything installed except the fan pulley to change it from the single belt Ram pulley to the dual belt MM pulley.. Guess what it won't fit!!! I need help on the option to fix it.. Also any information on the 4g63 swaps would be great! I purchased a fully built motor 700whp I plan on installing so the more knowledge I can receive would be appreciated!! Thanks!!

  2. #2



    Array
    Status
    Offline
    Join Date
    07-24-2012
    Posts
    2,363
    Location

    Washington State
    Vehicle

    1986 Mitsubishi Mighty Max
    Engine

    G63B
    Welcome to the forum.

    Jump in and explore the forum and try posting your request in the gen2 area of the forum for a possibly quicker response. Ask questions and give answers is always welcome here.

  3. #3

    Array
    Status
    Offline
    Join Date
    03-22-2016
    Posts
    9
    Location

    Easley S.C.
    Vehicle

    1987 Dodge Ram 50
    Engine

    G63B
    Thank you for the advice!!

  4. #4



    Array
    Status
    Offline
    Join Date
    03-26-2011
    Posts
    1,507
    Location

    Vacaville, CA
    Vehicle

    1989 Mitsubishi Mighty Max
    Engine

    4G63-T
    Welcome to the site, interested to see your swap being done.
    This sticky should help you out: http://www.mightyram50.net/vbulletin...ap-information

  5. #5

    Array
    Status
    Offline
    Join Date
    04-06-2011
    Posts
    482
    Location

    Jacksonville, FL
    Vehicle

    1990 Mitsubishi Mighty Max
    Engine

    G54B-T
    U have any pics? Im pretty sure my truck with power steering still uses a single groove water pump pulley. Water pump and alternator run on one belt and the power steering pump runs on another. Both belts then go on the 2 groove crank pulley.

  6. #6

    Array
    Status
    Offline
    Join Date
    03-22-2016
    Posts
    9
    Location

    Easley S.C.
    Vehicle

    1987 Dodge Ram 50
    Engine

    G63B
    I have a pic but idk how to post it here in the forum lol.. Either way if I try going around the water pump or under it my belt for the power steering is still hitting the fan pulley.

  7. #7

    Array
    Status
    Offline
    Join Date
    03-22-2016
    Posts
    9
    Location

    Easley S.C.
    Vehicle

    1987 Dodge Ram 50
    Engine

    G63B
    Could you post pics of the power steering pump , and the belt routing on the pulley?

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •