Well i got everything taken off and found no visible leaks and the seal looked fairly new, so i got to looking around and i found it was leaking from 3 oil pan bolts. It turns out that the holes in the block are actually stripped which is a pain because i dont have a tap and die or the money for a helicoil. So it looks like im going to go the silicon route and see if that will hold up. The bolts will tighten to about 6-7 lbs so do you think having them that tight with dome silicon would work? Hell if i have to ill just jb weld them in there for now until i can get the funds for a tap/die/helicoil.