Results 1 to 2 of 2

Thread: Temperature gauge

  1. #1

    Array
    Status
    Offline
    Join Date
    11-23-2015
    Posts
    3
    Location

    Lexington, Virginia
    Vehicle

    1988 Dodge Ram 50
    Engine

    G54B

    Temperature gauge

    I just replaced the head on my 2.6 and upon running the temp gauge isn't moving. I only removed the connection at engine, I checked the thermo unit and the ohms change with a rise in temp and checked the wires getting 4.9 volts across the 2 wires to the sensor and 4.9 v to ground on one wire. Does anyone have an experience with this system? Going to replace the sensor today and see if that makes a difference. Also the manual only 1 wire going to the sensor Yellow-red and I have two one green and the other yellow. Thanks

  2. #2

    Array
    Status
    Online
    Join Date
    06-15-2014
    Posts
    2,254
    Location

    Adelaide, South Australia
    Vehicle

    1985 Mitsubishi L200
    Engine

    G63B
    The temp sensor might need to be grounded on the green wires. Get it up to temp and ground it temporarily and see if you get any movement on the gauge.

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •