Results 1 to 2 of 2

Thread: Vacuum advance after weber install

  1. #1

    Array
    Status
    Offline
    Join Date
    08-15-2011
    Posts
    11
    Location

    West Columbia, SC
    Vehicle

    1984 Dodge Power Ram 50

    Vacuum advance after weber install

    Hey Guys curious about the vacuum advance after installing a weber 34/34 (im getting ready to install a 32/36 figured id go ahead and ask the question) there is enough vacuum on the distributor to almost fully advance the timing at idle should i set the timing with the vacuum line hooked up? also how much timing are you running on your G63B 2.0? any comments welcome!

  2. #2




    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,851
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    Be sure to use the ported vacuum to the advance unit - its located above the throttle plate. Run 7-10 degrees BTDC then adjust from there.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •