Tapped and installed set/grub screw in coolant port!



I have another issue though...I think Im missing something(s) for the throttle cable to mount properly assuming I have mounted everything correctly. Take a look at the pics.






"Boomerang" mounted on valve cover....I used the two bolts in the very center of the valve cover....dont know if this is correct, but it looked like the only logical place for it to go.


The Weber instructions say to recover the original throttle cable hold down from the original carburetor and mount it to the boomerang. I grabbed what I thought was the right bracket but now im starting to question myself. I had to break the original carb to get this thing off and it doesnt look like its the right thing at all.



I found the "keyed" 12 volt source for the choke so im only a couple steps away from seeing if its gonna run.