Wondering if there is a body lift kit anywhere for an 1st gen ram 50 custom. if there is a universal one or if spring spacers will work? Ride quality is good just want to fit some 31x10.5x15 in the front and still have some decent clearance.

Also i have a small vibration on take offs every now and then coming from rear diff. Haven't opened it up to look at fluid but will soon.

loud ping when shifting from park to reverse only. Sounds like a rock hitting a metal post and is pretty loud, also sometimes I'll put in park and it won't fully engage unless I push it all the way foreword.

still getting squeaking sound from u joints and center bearing. Been greasing them but is getting to where grease will only last a week or so before its back. Easy way to replace u joints? Do I need to rent a press?

Still getting a tiny leak from trans oil pan :/ when I flushed and replaced filter about a month ago I noticed the pan was not completely flat, like someone over torqued it and now it's wavy. I used the liquid gasket to seal because no shop anywhere had the correct fitting gasket for my 85. Thought if I laid it semi thick in the spots that were not flat it would fix the leak. It went a few hundred miles completely dry but just saw it had a couple drops again. Checked the level and it still reads right at full. Any other ideas or should I just try to find a good used trans oil pan?

Also planning on rhino lining the interior and suggestions on what to do for the two small rust holes in the cab? Bondo? I'm not to experienced at auto body stuff but plan on learning! I'm hoping to paint the entire exterior soon as well

Replaced all bushings and ball joints a couple weeks ago and though it took a whole weekend and it looked like I was in a fight club afterward I got it all done! Rides sooooo much better

Thanks in advance for any tips and advice this trucks my baby and just wanna make sure it's 100%