Results 1 to 6 of 6

Thread: dodge stealth v-6 swap QUESTIONS

  1. #1


    Array
    Status
    Offline
    Join Date
    03-26-2011
    Posts
    678
    Location

    Stafford, VA
    Vehicle

    1995 Mitsubishi Mighty Max
    Engine

    Chevy V8

    dodge stealth v-6 swap QUESTIONS

    does anyone know off hand what transmissions will bolt up if any. i have done a little searching. i can get a complete car for a good price. 140k strip the swap out and make most of my money back off parts and scrapping.

    it is fwd and would it be possible to make it posi and just use one of the axle outlets to power my mighty max?

    anyone know anything about this car?

    thanks in advance

  2. #2

    Array
    Status
    Offline
    Join Date
    03-26-2011
    Posts
    260
    Location

    Savannah, GA
    Vehicle

    1988 Dodge Ram 50
    Engine

    G54B
    is this a v6 twin turbo stealth? I've been waiting for someone to do that swap for a long time. But even still the regular dohc should be nice. I believe it's pretty much the same motor so you may be able to use the v6 mightymax trans. Though i'm not sure if all of those were 4wd or not.

  3. #3



    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,112
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    I'm pretty sure the wide block MM truck tranny will fit the 3.0 stealth block using the 240 mm clutch setup from the 3.0 truck or starquest tsi. It would be an interesting swap that I thought about many times but that's as far as I got. Even thought about the 3.5 / 3.8 from the 95 up monteros, but no follow through.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

  4. #4


    Array
    Status
    Offline
    Join Date
    03-26-2011
    Posts
    678
    Location

    Stafford, VA
    Vehicle

    1995 Mitsubishi Mighty Max
    Engine

    Chevy V8
    thanks guys....im either getting this stealth or another max that is wrecked bent front clip and frame..but it has a full hyrdo set up on it..tilt bed and other stuff. i would like to buy both honestly.

    lethal...it is not the TT model. and i believe it is just the single cam...

  5. #5

    Array
    Status
    Offline
    Join Date
    03-26-2011
    Posts
    24
    Location

    Buhl, ID
    Vehicle

    1989 Dodge Power Ram 50
    Engine

    G64B
    I recently put in a 3.0L V6 into my 89 4X4 with a 2.6. Had a donor PU. The 4 cylinder transmissions will not bolt up. The V6 trans was a much bigger trans. Also, be careful with the clutch. The V6 trans has a hydraulic clutch and the 4 bangers have a cable.

  6. #6



    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,112
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    thanks for the info - I wasn't sure on that.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •