Results 1 to 2 of 2

Thread: Need help on Hydro to Cable km-145

  1. #1

    Array
    Status
    Offline
    Join Date
    08-20-2015
    Posts
    20
    Location

    Boise, ID
    Vehicle

    1984 Dodge Power Ram 50
    Engine

    4D55-T

    Need help on Hydro to Cable km-145

    So I recently purchased a low mile hydraulic transmission with the 4wd from the junkyard. The problem is that it is hydraulic trans versus my cable setup, my question is there any way to covert the hydraulic transmission to work with my cable set up. I have the entire conversion to switch to a complete set but I wanna see if there another way to make it work. The trans is out of a 86 raider and my truck is a 84 power ram with a cable. Any info or suggestions would be greatly appreciated as I would need it back together to go camping this weekend.

  2. #2

    Array
    Status
    Offline
    Join Date
    03-11-2014
    Posts
    25
    Location

    Phoenix Az
    Vehicle

    1987 Dodge Ram 50
    Engine

    G54B
    Hello, kind of old thread but what the heck.

    I had the same issue where I blew up my cable tranny and aquire a hydro. I couldn't figure out how to adapt the cable so I ended up removing the cable clutch pedal and replacing with a whole hydro set up.... pedal, master cylinder, slave cylinder, fluid line. Now after some elbow grease, she works just fine. And in all reality, the hydro clutch is a smoother operation

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •