Results 1 to 6 of 6

Thread: rear main oil seal tq: specs???

  1. #1

    Array
    Status
    Offline
    Join Date
    11-23-2013
    Posts
    344
    Location

    pa
    Vehicle

    1988 Mitsubishi Mighty Max
    Engine

    G63B

    Question rear main oil seal tq: specs???

    Like title says I'm looking for the (Lb) torque specks for the bolts on the rear main oil seal ?
    Thanks.

    2.0 g63b

  2. #2



    Array
    Status
    Offline
    Join Date
    03-16-2011
    Posts
    3,614
    Location

    Sacramento, CA
    Vehicle

    1979 Dodge D-50
    Engine

    Chevy V6
    Is the rear main held onto the block by 2 small studs and nuts?
    Or are you talking about the flywheel bolts?
    Members come and members go, But the board keeps track of them.
    Check out the Fear Monger by
    clicking HERE.

    The MightyRam50 site is sponsored in part by On Site Concrete Inc.

  3. #3

    Array
    Status
    Offline
    Join Date
    11-23-2013
    Posts
    344
    Location

    pa
    Vehicle

    1988 Mitsubishi Mighty Max
    Engine

    G63B
    This is what I'm talking about . The bolts surrounding it what are ylthe torque specks so I dont over or undertighten them.Name:  attachment-3.gif
Views: 147
Size:  4.0 KB

  4. #4

    Array
    Status
    Offline
    Join Date
    03-26-2011
    Posts
    66
    Location

    Montrose, CO
    Vehicle

    1991 Mitsubishi Mighty Max
    Engine

    4G64
    5 bolts with 10mm heads right? 8ft-lbs I think but wait for someone else to confirm, I will pull out my manual tomorrow to double check.

  5. #5



    Array
    Status
    Offline
    Join Date
    03-16-2011
    Posts
    3,614
    Location

    Sacramento, CA
    Vehicle

    1979 Dodge D-50
    Engine

    Chevy V6
    10 Inch pounds not foot lb's. Just nice and snug with a 1/4" ratchet is fine. It's not that critical. Use silicone everywhere except on the seal.
    Members come and members go, But the board keeps track of them.
    Check out the Fear Monger by
    clicking HERE.

    The MightyRam50 site is sponsored in part by On Site Concrete Inc.

  6. #6

    Array
    Status
    Offline
    Join Date
    11-23-2013
    Posts
    344
    Location

    pa
    Vehicle

    1988 Mitsubishi Mighty Max
    Engine

    G63B
    Ok 10 inch pounds us what I went with and used( arboiatic)sp? sealer around the inside of the gasket As the Manual shows. . Thanks.

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •