Results 1 to 5 of 5

Thread: Installing rollbar lights any advice?

Hybrid View

  1. #1

    Array
    Status
    Offline
    Join Date
    03-25-2015
    Posts
    30
    Location

    Reno
    Vehicle

    1987 Dodge Ram 50
    Engine

    I.D.K.?

    Installing rollbar lights any advice?

    Thank you all for the information needed to restore this little beast. Three more major projects but any ideas on how to installed lobar lights? The wiring diagram is blah.
    Attached Images

  2. #2

    Array
    Status
    Offline
    Join Date
    04-09-2014
    Posts
    550
    Location

    sheffield, vt
    Vehicle

    1978 Dodge D-50
    Engine

    G63B
    i drilled holes & ran the wires thru the inside of the bar. tack welded bottom of each thread so no-one could steal my lights easily. as for wiring you should use a heavy duty relay (i use a 100 amp)...a search online should produce a diagram...concentrate on very good grounds...i ran an extra ground to the frame.

  3. #3


    Array
    Status
    Offline
    Join Date
    04-04-2011
    Posts
    712
    Location

    Columbus, OH
    Vehicle

    1992 Mitsubishi Mighty Max
    Engine

    Other
    use a fuse... :-)

  4. #4




    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,851
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    look into putting a higher output alternator on if you are running halogen lights, or you will kill the battery quickly. Factory alternators are only 45 amps - get a 75 to 100 amp one from a starquest or expo van.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

  5. #5

    Array
    Status
    Offline
    Join Date
    03-25-2015
    Posts
    30
    Location

    Reno
    Vehicle

    1987 Dodge Ram 50
    Engine

    I.D.K.?
    Got some LED fog lights and was hoping to get an LED bar to avoid using more output than I should. Light bar will come last I far the fog lights don't look bad. Have to repair front end since it's a safety issue.

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •