Results 1 to 4 of 4

Thread: Replacing front end-need advice

Hybrid View

  1. #1

    Array
    Status
    Offline
    Join Date
    03-25-2015
    Posts
    30
    Location

    Reno
    Vehicle

    1987 Dodge Ram 50
    Engine

    I.D.K.?

    Replacing front end-need advice

    Bushings are gone from left and right.

    ball joints look squished to heck.

    grime buildup all over the control arm tells me it was never replaced since stock

    would like advice on items to replace the front end parts.

    Much appreciated in in this matter. Autozone/oreilly is getting rich off me

    so far I replaced the grill stereo tires shocks door assembly

    i want to replace the door panel foam, carpet and bench seat and I'll be done

  2. #2




    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,851
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    get urethane bushings for lower control arms, sway bar, and strut rod bushings - they are on ebay. check rockauto and ebay for ball joints, tie rods, pitman and idler arm rebuild kit or full replacement arms. lower control arms can be replaced if bad, as new aftermarket and oems are available.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

  3. #3

    Array
    Status
    Offline
    Join Date
    03-25-2015
    Posts
    30
    Location

    Reno
    Vehicle

    1987 Dodge Ram 50
    Engine

    I.D.K.?
    Much appreciated photos will come up upon completion

  4. #4

    Array
    Status
    Offline
    Join Date
    06-12-2013
    Posts
    140
    Location

    west valley, silicon valley, bay area, ca
    Vehicle

    1993 Mitsubishi Mighty Max
    Engine

    4G64
    I knew daredevils and I ain't got nothin' against them, ........it's just they're all dead.

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •